5 To 14" 15 Amp Metal Hardwired 12 Outlets Power Strip With IEC C14 Input & Switch
SFC-IEC-A1B series 5 to 14" 15Amp Hardwired Power Strip with 12 Outlets
This hard wired type power strip is good for installation in your kitchen, cabinet, on the rack and so on. It is not for normal wall outlets. There is no power cord and plug with this unit.
|Description:||5 to 14" 2 Outlet Hardwired Power Strip|
|Power Strip Measurement:||L5 to14" x W1.614" x H1.255" (133 to 355 x 45 x 42) *|
|Outlet Color:||Black, white, grey or other|
|Outlet Orientation:||Vertical or level|
|Receptacle Type:||NEMA 5-15R|
|Outlet Spacing:||0.12to 8.39" (3 to 213mm) (center to center)|
|IEC C14 Inlet:||on Top or Bottom Cover or Both Sides or Ends)|
|Voltage Input/Output:||110-125V 60Hz|
|Mounting Tabs:||On both ends or bottom|
|Mounting Clips:||Mounting Clips included|
1.Turn one outlet into Multiple-outlets with the rocker switch power strip. Simply plug the power strip into a three-pronged, properly grounded AC outlet, press the rocker switch to "on", the work indicator light (red), it means that the power supply is normally connected and work; otherwise, can not be used, should be timely repair or replacement by a professional, a licensed electrician or an electric engineer;The load power can not exceed the rated volt:125V power socket, the socket ground wire to do reliable connection with the ground;
2.When the all load power exceeds the rated output watts:1800W power of the socket or short circuit, the socket will automatically disconnect the power supply, in order to protect the power supply security;
3.Using power strip by certificated.
4.Since most electronics continue to use power when in standby mode, The rocker switch of power strip can be used to completely shut off electronics when not in use, helping to conserve energy.
5.Please inspect power strip regularly and pull out main plug wall socket and remove all appliances berfore clean the product.
6.This unit is for indoor use only.
7.This unit is not intended for use in or around wet or potentially wet areas including, but not limited to, aquariums, saunas, showers and fountains.
Risk of Electric Shock!
Before installation, you may need to get a IEC C13 Outlet. Decide your wire gauge, and ask store attendant for assistance what color of connectors you should get) from your local hardware or electric supply or home improvement stores.
Minimum tools required: A fine to medium fine philips screw driver, and a pair of scissors, and a pair of mid size slip joint pliers
1. Turn off electricity in the house
2. Decide where to place this unit
3. Choose the side you want the cord exit to choose IEC C14 Built in power strips
4. Match the color of the wires and secure the wire connection with proper wire connectors built in IEC C13 plug.(different wire gauge use different colored wire connectors)
We also custom manufacture for our customers.
|Contact Person :||Mr. Light Sheng|